SilverCrest SEM 1100 A2 Mode D'emploi page 72

GB
70
NOTICE
► Compaction of the coff ee powder is an essential process for the prepara-
tion of an espresso. If the espresso powder is compacted very strongly, the
espresso runs through more slowly and there is more crema. If the espresso
powder is not so strongly compacted, the espresso runs through more
quickly and it creates very little crema.
4) Insert the sieve carrier w into the appliance by placing it at the marking
"INSERT" and then turning it anticlockwise to the marking "LOCK".
5) Place one (or two) cup(s) under the sieve carrier openings. We recommend
that you rinse the cups out with hot water beforehand, so that the espresso
does not cool so quickly.
6) As soon as the green heating-up control lamp 4 glows, you can turn the
rotary switch 5 to the position "
WARNING
Never remove the sieve carrier w during the espresso output!
The resulting spray of hot espresso would lead to injury!!
Always ensure that the rotary switch 5 stands at "
►
ve the sieve carrier w.
NOTICE
► This appliance is fi tted with a pre-brew function. This means that the hot
water, before it is pressed through the espresso powder, stands for a short
time in the fi lter holder. This refi nes the aroma of the espresso.
7) When the cup(s) are fi lled to the desired quantity (about 20 ml), turn the
rotary switch 5 back to the position "
You can now drink the espresso.
8) Switch the appliance off with the on/off switch 3.
NOTICE
► After 3 minutes the appliance will switch itself off automatically.
9) After every use remove the espresso powder from the espresso sieve 0 q.
Remove the sieve holder w from the appliance. Flip the sieve blocker e
upwards so that the espresso sieve 0 q cannot fall out of the sieve holder
w. Now empty the espresso sieve 0 q. Always dispose of the espresso
powder or espresso pads in an environmentally friendly manner, for example,
with the organic waste.
". The espresso fl ows into the cup(s).
" before you remo-
".
SEM 1100 A2