Model Description; Specifications; Plug Configurations - Hatco 3CS Série Manuel D'installation

Masquer les pouces

Table des Matières

Les langues disponibles

English

All Models

The 3CS and FR Model water heaters mount under a sink or

holding vessel, leaving the interior of the holding vessel free of

obstructions. They include a stainless steel front, powdercoated

body, and two drain outlets. These water heaters feature a

unique dual reservoir system designed for cleaning

convenience. One reservoir contains the heating element and

always should be filled with water. The other reservoir traps and

collects soil carried from a sink or holding vessel .

Each unit comes with a one year parts and labor warranty and

a five year limited tank warranty. Units are shipped completely

assembled and ready to install with all gaskets and fittings.

Options include a security package and a stainless steel body

and base. A temperature monitor and a temperature light are

available for 3CS Models. A flush hose kit is available as an

accessory. Refer to the OPTIONS AND ACCESSORIES section

for details.

3CS Models

Hatco 3CS Model heaters are designed for use with any manual

dishwashing operation. These units maintain sanitizing rinse

water above 180ºF (82ºC).

FR Models

Hatco FR Model heaters are designed to be used with a Bain-

Marie or Food Rethermalizer to heat or hold foods at

temperatures between 140ºF and 190ºF (60° and 88ºC). The

desired holding temperature is maintained by an adjustable

water temperature control.

FRC-I and FRC-II Models

Hatco Corn Cooker models FRC-I and FRC-II utilize a Hatco

FR-3 heater. The Corn-Cooker is completely assembled and

comes equipped with an electrical power cord and plug. The

unit may include a stand or as a vessel inserted into a

countertop.

Plug Configurations

Some FR units are supplied from the factory with an electrical

cord and plug installed and are shipped with a receptacle. Plugs

and receptacles are supplied according to the applications.

WARNING

ELECTRIC SHOCK HAZARD: Units supplied with an

electrical cord, plug, and receptacle require installation of

receptacle to on-site electrical system. Connection must

be properly grounded and of correct voltage, size, and

configuration for electrical specifications of unit. Contact a

qualified electrician to determine and install proper

electrical connection.

NOTE: The specification label is located on the lower right side

on the front of the unit. See label for serial number and

verification of unit electrical information.

Form No. 3CSFRM-0415