en
Maintenance and daily cleaning
Maintenance and
daily cleaning
W Risk of electric shock!
Unplug the appliance before cleaning it.
Never immerse the appliance in water.
Do not use a steam cleaner.
■ Wipe the outside of the appliance with a
soft, damp cloth.
■ Do not use abrasive cloths or cleaning
agents.
■ Always remove any limescale, residues
of coffee or milk, cleaning or descaling
solution immediately. Such residue can
cause corrosion.
■ New sponge cloths may contain salts.
Salts can cause rust film on stainless
steel and must therefore be washed out
thoroughly before use.
■ Pull the drip tray (8c) with the coffee
grounds container (8b) forward and
out. R emove the panel (8a) and the
grate (8d). Empty and clean the drip tray
and coffee grounds container.
■ Remove the float (8e) and clean with a
damp cloth.
■ Wipe out the inside of the appliance
(holder, trays) and the drawer for ground
coffee (this cannot be removed).
12
L
Do not put the following items in
the dishwasher: drip tray panel (8a),
brewing unit (5a).
M
The following items are dishwasher-
safe: drip tray for coffee outlet (8c),
coffee grounds container (8b), grate
for coffee outlet (8d), aroma cover
(2), all parts of the milk frother (6) and
powder spoon (19).
■ Wipe out the inside of the appliance (tray
holders and drawer).
Important: The drip tray and coffee
grounds container should be emptied and
cleaned every day in order to prevent
deposits.
N.B.: If the appliance is cold when switched
on with the power switch O / I (9) or if it
switches off automatically after coffee has
been dispensed, it rinses automatically. In
other words the system cleans itself.
Important: If the appliance has not been
used for a prolonged period of time (e.g.
after a vacation), clean the entire appliance
thoroughly, including the milk system and
brewing unit.
Cleaning the milk system
If the milk system was not cleaned after
milk has been dispensed, after a certain
amount of time the message Clean milk
system! will appear on the display.
Clean the milk system immediately after use!
To pre-clean the milk system automatically:
■ Select j by turning the rotary knob (15).
■ Place a tall, empty container under the
outlet (6a).
■ Push the outlet as close as possible to
the container.
■ Place the end of the milk tube (6c) into
the container.
■ Press the start button (10).
The machine automatically releases water
into the container and vacuums it up again
via the milk tube to rinse the milk system.