Maintenance And Daily Cleaning - Siemens TE506 RW Serie Mode D'emploi

Important: Dried milk residue is difi cult
to remove, so the milk frother (6) must be
cleaned with lukewarm water immediately
after use and rinse using the
system
programme (see page 15).
Maintenance and daily
cleaning
Risk of electric shock!
¡
Unplug the appliance before cleaning it.
Never immerse the appliance in water.
Do not use a steam cleaner.
● Wipe the outside of the appliance with a
soft, damp cloth.
● Do not use abrasive cloths or cleaning
agents.
● Always remove any limescale, coffee,
milk or descaling l uid residue immediate-
ly. Such residue can cause corrosion.
● Pull the drip tray (8c) with the coffee
grounds container (8b) forward and
out. Remove the panel (8a) and the
grate (8d). Empty and clean the drip
tray and coffee grounds container.
● Remove drawer (4) and clean.
● Do not put the following items in the
dishwasher: cover of the storage com-
partment (5c), drip tray panel (8a), drawer
(4), brewing unit (5a).
TE_506_509_1RW.indb 15
All manuals and user guides at all-guides.com
Rinse milk
● The following items are dishwasher-
safe: drip tray for coffee outlet (8c),
coffee grounds container (8b), grate for
coffee outlet (8d), aroma cover (2) and
measuring spoon (19).
● Wipe out the inside of the appliance (tray
holders and drawer).
Important: Drip tray for coffee outlet (8c)
and coffee grounds container (8b) should
be emptied and cleaned daily to prevent
mould from developing.
N.B.: If the appliance is cold when switched
on with the power switch O / I (9) or if it
switches off automatically after coffee has
been dispensed, it rinses automatically. In
other words the system cleans itself.
Important: If the appliance has not been
used for a prolonged period of time (e.g.
after a vacation), clean the entire appliance
thoroughly, including the milk system and
brewing unit.
Do not put the lid and the insulating cover
of the milk container (22) in the dish-
washer. The inside of the milk container is
dishwasher-safe.
Cleaning the milk system
If the milk system was not cleaned after
milk has been dispensed, after a certain
amount of time the message
system!
will appear on the display.
Clean the milk system immediately after use!
To clean, leave the rotary selector (6b) in the
same position it was in when last used.
To pre-clean the milk system automatically:
f
1. Select by turning the rotary knob (15).
2. Place a tall, empty container under the
outlet (6a).
3. Push the outlet as close as possible to
the container.
4. Place the end of the milk tube (6c) into
the container.
5. Press the start button (10).
en de
Clean milk
15
24.01.2013 15:55:20