Siemens TE506 RW Serie Mode D'emploi page 16

en de
The machine automatically releases water
into the container and vacuums it up again
via the milk tube to rinse the milk system.
The rinse procedure stops automatically
after about 1 minute.
6. Empty the container and clean the milk
tube (6c).
In addition to this, clean the milk system
thoroughly at regular intervals (by hand or
in the dishwasher).
Dismantling the milk system for cleaning:
1. Pull the milk frother (6) forward out of
the appliance.
2. Dismantle the milk frother into its indi-
vidual parts (6a to 6d) (see i gure C at
the start of the operating instructions).
3. Clean the individual parts with a deter-
gent solution and a soft brush. If neces-
sary, soak in a warm detergent solution.
4. Rinse all parts with clear water and dry
them.
5. Reassemble all the parts and replace
fully in the appliance.
16
TE_506_509_1RW.indb 16
All manuals and user guides at all-guides.com
Risk of scalding!
¡
Use this appliance only after the milk frother
(6) has been fully assembled and installed.
Cleaning the brewing unit
Clean the brewing unit regularly!
To pre-clean the brewing unit automatically:
e
1. Select by turning the rotary knob (15).
2. Place an empty glass under outlet (6a).
3. Press the start button (10).
The appliance rinses.
In addition to the automatic cleaning
programme, the brewing unit (5a) should
be removed regularly for cleaning.
(See i gure E at the start of the operating
instructions.)
1. Switch the appliance off at the power
on/off switch O / I (9). No buttons are lit.
2. Open the door (5b) to the brewing unit.
3. Slide the red lock (5e) on the brewing
unit completely to the left.
4. Press the red button (5d), grasp the
brewing unit by the recessed grips and
remove carefully.
5. Rinse the brewing unit (5a) thoroughly
under running water.
24.01.2013 15:55:23