Menu Settings; Adjusting The Grinding Unit - Siemens TE515 Série Mode D'emploi

Menu settings

You can adapt the appliance to your
i ndividual needs in the menu settings.
■ Hold the k off / i button (13) down for at
least 3 seconds.
■ Press the k off / i button (13) repeatedly
until the required menu item appears in
the display.
■ Select the required setting with the u pper
rotary knob (15).
■ Confirm by pressing the start button (10).
To leave the menu without making any
changes, turn the rotary selector to Exit and
press the start button (10).
You can set the following:
Shut off: Here you can set the time
span after which the appliance automati-
cally switches off following the last drink
preparation. A time between 15 minutes and
4 hours can be set. The default time can be
shortened to save energy.
To save power you can specify a shorter
period.
Filter: Here you can set whether a water
filter is being used. If a water filter is not
being used, turn the setting to No / Old. If a
water filter is being used, turn the setting to
Activate filter. New water filters have to be
rinsed before use (see "Water filter").
Start Calc'n'Clean: The service pro-
grammes (Calc'n'Clean / descaling /
cleaning) can be selected manually
here. Press the start button (10) and run
the selected programme (see "Service
Programmes").
Temp.: The brewing temperature (high /
middle / low) can be set here.
Language: The display language can be set
here.
Water hardness: The water hardness
setting can be adjusted on this appliance.
It is important to set the water hardness
c orrectly, so that the appliance indicates
accurately when the descaling programme
should be run. The factory setting for the
water hardness is 4.
You can check the water hardness using
the enclosed test strip or by asking your
local water supplier. If a water softening
system is installed in the house, please
select the Softening system.
Dip the test strip briefly in water, gently
shake off any drips, and check the result
after one minute.
Level Water hardness
German (°dH)
1 1-7
2 8-14
3 15-21
4 22-30
Drink counter: This displays how many
drinks have been dispensed since the
appliance was first put into operation.

Adjusting the grinding unit

The rotary selector (3) adjusts the grind
settings from coarse to fine.
W Warning!
Adjust the grinding unit only while it is
r unning! Otherwise the appliance may
be damaged. Do not reach into the
grinding unit.
■ While the grinding unit is running, adjust
the rotary selector (3) from fine (a: Turn
anticlockwise) to coarse (b: Turn
clockwise) as required.
a
Menu settings
French (°fH)
1-13
14-25
26-38
39-54
b
en
9