Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
2. Dismounting the saw blade
Dismount the saw blade by reversing the mounting procedures described in paragraph 1 above.
The saw blade can easily be removed after lifting the cutter shaft guard.
CAUTION:
Never attempt to install saw blades larger than 10" (255 mm) in diameter.
Always install saw blades that are 10" (255 mm) in diameter or less.
OVERLOAD PROTECTIVE DEVICE FOR POLY–V–BELT
The power of the motor is transmitted to the saw blade by a Poly–V–Belt. When the Poly–V–Belt becomes
overloaded, the overload protective devise cuts off the current to stop the motor.
In this case turn the switch off immediately and raise the handle to its initial position. Then turn the switch
on and after running the tool for 20 seconds without a load for cooling of the motor. Then start the cutting
operatinon. The Poly–V–Belt or the motor will be damaged if the overload protective device turns off
frequently.
CAUTION:
When the overload protective device stops the motor, the motor will start by turning
the switch on after turning it off. When turning the switch on, make sure that the
saw blade is not halfway in the material.
MAINTENANCE AND INSPECTION
WARNING:
To avoid an accident or personal injury, always confirm that the trigger switch is turned
OFF and the power plug has been disconnected from the receptacle before performing
any maintenance or inspection of this tool.
1. Inspecting the saw blade
Always replace the saw blade immediately upon the first sign of deterioration or damage.
A damaged saw blade can cause personal injury and a worn saw blade can cause ineffective operation
and possible overload to the motor.
CAUTION:
Never use a dull saw blade. When a saw blade is dull, its resistance to the hand
pressure applied by the tool handle tends to increase, making it unsafe to operate
the power tool.
2. Inspecting the carbon brushes (Fig. 37 and Fig. 38)
Wear Limit Line
3/16" (5 mm)
43/64" (17mm)
Fig. 37
Brush Cap
Motor Housing
Fig. 38
3. Inspecting the mounting screws
Regularly inspect each component of the power tool for looseness.
Re-tighten mounting screws on any loose part.
WARNING:
To prevent personal injury, never operate the power tool if any components are loose.
All manuals and user guides at all-guides.com
The carbon brushes in the motor are expendable parts.
If the carbon brushes become excessively worn, motor trouble
might occur.
Therefore, inspect the carbon brushes periodically and replace
them. Check the carbon brushes after the first 50 hours of use for a
new machine or after a new set of carbon brush have been installed.
After the first check, examine them after each about 10 hours of
use until such time that replacement is necessary.
When the carbon on either brush is worn to 3/16" (5 mm) in length
or if either spring or shunt wire is burned or damaged in any way,
replace both carbon brushes (see Fig. 37). If the carbon brushes
are found serviceable after removing, reinstall them in the same
position as before removed.
Also, keep the carbon brushes clean so that they will slide smoothly
within the brush holders.
The carbon brushes can easily be removed after removal of the
brush caps (see Fig. 38) with a slotted (minus) screwdriver.
English
21
Publicité
Table des Matières
