Linea 2000 DOMO DO927BFK Mode D'emploi page 73

pper door and move
osite side. You may
he door block to fit the
3. Odstráňte skrutky z prostredného pántu. Pánt so závesom odoberte a pripravte ich na
druhú stranu. Dvierka nadvihnutím odoberte a postavte bokom na mäkkú podložku.
dle hinge by removing
he lower door and place
urface to prevent it from
dle hinge by removing
he lower door and place
urface to prevent it from
ws' covers and place
osite side.
ws' covers and place
on of the plastic tube and
4. Všetky odnímateľné časti na hornej strane dverí presuňte na druhú stranu.
osite side.
p of the lower door.
Na spodnej strane dverí nájdete zarážku a teflónovou krytku pántov, ktoré taky presuňte
na druhú stranu.
n of the plastic tube and
r block, screw and plastic
p of the lower door.
ower door and move
osite side. You may
r block, screw and plastic
the door block to fit the
ower door and move
osite side. You may
he door block to fit the
5. Zo spodnej časti prístroja odskrutkujte nastaviteľnou nožičku s pántom.
LATION
Na opačnej strane tiež odskrutkujte nožičku a prehoďte ich.
6. Prehodenie výškovo nastaviteľné nožičky a pánt dôkladne dotiahnite.
ve the lower screws and lower
from the unit bottom. Reverse the
ATION
hinge, move and secure it with
wer screws to the opposite side of
it bottom. Carefully set the lower
e the lower screws and lower
back into place, inserting it onto the
rom the unit bottom. Reverse the
hinge.
inge, move and secure it with
wer screws to the opposite side of
t bottom. Carefully set the lower
ack into place, inserting it onto the
inge.
7. Dvere opatrne nasaďte na novo prehodenie pánty. Pred dotiahnutím riadne skontrolujte,
aby dvere boli vertikálne Aj horizontálne vyrovnané. Tesnenie zavretých dverí musí
e the middle hinge. Screw the
doliehať rovnomerne po celom obvode. Až keď sú dvere takto rovno usadené, tak
e hinge onto the opposite side of
dotiahnite pánty. Vráťte stredový pánt a tým dvere zaistite vo svojej polohe.
it.
e the middle hinge. Screw the
sure the lower door is aligned
hinge onto the opposite side of
rizontally and vertically, so that
t.
e seals are closed on all sides
fore finally tightening the hinge.
ure the lower door is aligned
izontally and vertically, so that
seals are closed on all sides
lly set the upper door back into
ore finally tightening the hinge.
inserting in onto the middle hinge.
www.domo-elektro.be
the upper hinge and screw it
Middle hinge
Middle hinge
unscrew
unscrew
1/2/16 10:43 am
1/2/16 10:43 am
73
DO927BFK