Audio Button; Tuner - Teac MC-DV250 Manuel Du Propriétaire

1
2
80

Tuner

1
Select FM or AM by pressing the FM/AM button (or the
FUNCTION button of the main unit).
Make sure the antennas have been connected
(see page 14-16).
2 Press the TUNING button to tune in a station.
Hold down the TUNING button of the remote control unit for
more than 0.5 seconds.
The AUTO indicator lights, and the unit starts searching for a
station.
When a station is tuned in, the tuning process will stop
automatically.
If you want to stop the tuning process, press the TUNING
button.
When the TUNING button of the remote control unit is
pressed momentarily (0.5 second or less), the frequency
changes by a fixed step (FM: 50 kHz steps, AM: 9 kHz steps).
Press the TUNING button repeatedly until the station you want
to listen to is found.
Repeat this step until the station you want to listen to is
found.
< The TUNED indicator lights when a broadcast is correctly
tuned in.

AUDIO Button

Pressing this button alternates between Stereo mode and
Mono mode.
Stereo:
FM stereo broadcasts are received in stereo and the "ST"
indicator lights in the display.
Mono:
To compensate for weak FM stereo reception, select this
mode. Reception will now be forced monaural, reducing
unwanted noise.
ENGLISH