Hendi 210215 Mode D'emploi page 13

• lean the Plexiglas blade removal tool on the blade
to obtain the coupling of the blade holes with the
two screws (e), turn the blade until it reaches the
correct position;
• slightly tighten the screw (e).
WARNING: The blade guard must be cleaned with
hot water and neutral detergent.
6.2.3. CLEANING OF THE SHARPENER
The sharpener cleaning operation is carried out
by rubbing the grinding moles with a brush. The
moles must be placed in the safety position which
6.2.4. CLEANING OF THE DEFLECTOR
To remove the defl ector unscrew the two screws (a)
locking the defl ector (see Fig.8).
Clean the defl ector with hot water and neutral de-
tergent.
Fig. 7 – Assembling the Plexiglas blade removal tool (b)
means that they must be turned towards the side
opposite to the blade.
Fig. 8 - View of the deflector
EN
13