Jet JBS-22 Mode D'emploi page 11

Machine vibrates excessively
Stand on uneven floor-
adjust stand for even support.
Brush sander burns wood
*Depth of cut excessive-
reduce depth of cut.
*Feed rate too slow-
Increase feed rate.
Uneven brushing surface
*Uneven federate-
Conveyor belt slipping (see above).
*Drum out of alignment-
Fine-tune drum alignment.
*Machine vibrations (see above)
10. Available accessories
Stock number 60-6004
Wire brush-drum
Stock number 60-6005
Brush-drum 46 grit
Stock number 60-6001
Brush-drum 80 grit
Stock number 60-6002
Brush-drum 120 grit
Stock number 60-6003
Brush-drum 240 grit
Stock number 60-0321-P
Conveyor belt 100 grit
11