Environment; Pre-Start Checks; Start And Stop Procedure - Belle Group BHB BREAKERS Manuel De L'opérateur

A used machine must be treated and disposed of in such a way that the greatest possible portion of the material can be
recycled and any negative inÀ uence on the environment is kept as low as possible.
NOTE:-
Before a used machine is scrapped, it must be emptied and cleaned from all hydraulic oil. Remaining
hydraulic oil must be deposited.

Pre-Start Checks

The following checks should be made each time you start to use the breaker. All these checks concern the serviceability of the breaker.
Some concern your safety:
• Clean all Decals. Replace any that are missing or cannot be read. These can be ordered from the Spare Parts list.
• Inspect the hoses generally for signs of damage.
• Inspect the working tool for wear and damage.
• Do not use an excessively worn or damaged tool.
• Connect the tool.
• Ensure that the hydraulic couplings are clean and fully serviceable.
• Do not invert the breaker without ¿ rst isolating it from the power source. The working tool might be ¿ red out while connecting it, if
the breaker is connected to the power source.
• Ensure that any power source you plan to use is compatible with the breaker model used (see the "Technical data" section). Belle
Group recommends using an LFD oil À ow divider, if the À ow from the power source can exceed the maximum allowed oil À ow.
Starting
1) Check that the 'Steel' is in good condition and pressed fully home in the nose of the breaker.
2) Check that the latch is locked, so that the 'Steel' does not fall out.
3) Remove the protective caps from the quick-release couplings.
4) Clean the quick-release couplings if needed and connect the tail-hoses to the extension hoses of the power unit.
5) Place the breaker at a right angle on the material to be broken and activate the trigger lever.
Stopping
1) Release the trigger. Press the breaker against the surface, until the breaker has stopped completely.
2) Stop the power source.
3) Disconnect the hoses and ¿ t the protective caps to the quick-release couplings.

Environment

Pre-Start Checks

Start and Stop Procedure

28