Health And Safety; Pre-Start Checks; Environment - Belle Group BWR 650 Manuel De L'opérateur

Vibration
Some vibration from the compaction operation is transmitted through the handle to the operator's hands. The Belle Group 'Minipac' has
been specifi cally designed to reduce hand/arm vibration levels. Refer to Technical Data section for vibration levels and usage times
(recommended maximum daily exposure time). DO NOT exceed the maximum usage times.
PPE (Personal Protective Equipment).
Suitable PPE must be worn when using this equipment i.e. Safety Goggles, Gloves, Ear Defenders, Dust Mask and Steel Toe capped
footwear (with anti-slip soles for added protection). Wear clothing suitable for the work you are doing. Always protect skin from contact
with concrete.
Dust.
The compaction process can produce dust, which may be hazardous to your health. Always wear a mask that is suited to the type of
dust being produced.
Fuel.
Do not ingest fuel or inhale fuel vapors and avoid contact with your skin. Wash fuel splashes immediately. If you get fuel in your eyes,
irrigate with copious amounts of water and seek medical attention as soon as possible.
Exhaust Fumes.
Do not operate your 'BWR' Roller indoors or in a confi ned space, make sure the work area is adequately ventilated.
WARNING
Pre start-up inspection.
The following Pre-start-up inspection must be performed before the start of each work
session or after every four hours of use, whichever is fi rst. Please refer to the service
section for detailed guidance. If any fault is discovered, the 'MPC300' must not be used until the fault is rectifi ed.
1. Thoroughly inspect the machine for signs of damage.
2. Check hoses, fi ller openings, drain plugs and any other areas for signs of leakage. Fix any leaks before operating.
3. Check the engine oil level and top up as necessary.
3-1. Place the machine on a level surface, and chack the oil level of the engine.
3-2. Remove the oil gauge, and observe that the oil is up to the rim of the fi ller port. Use proper engine oil with the proper viscosity
(SAE 10W-30 recommended)
4. Check the engine fuel level and top up as necessary. Use clean fuel. Use of contaminated fuel may damage the fuel system.
5. Check the Air Filter is clean. Excessive dirt/dust accumulation within the fi lter element will cause erratic engine operation.
Clean the air fi lter element when it is contaminated. (See Servicing Section)
6. Check the function of Operators Controls. Make sure that the Drive lever, Vibration lever, Throttle lever, Parking Lever, and the
safety device for the reverse motion moves smoothly.
Safe Disposal.
Instructions for the protection of the environment.
The machine contains valuable materials. Take the
discarded apparatus and accessories to the relevant
recycling facilities.
Health & Safety
The exhaust fumes produced by this equipment are highly toxic and can kill!

Pre-start Checks

Environment

Component
Operator Handle
Main Frame
Hydraulic Oil Tank
Water Tank
Cover
Hydraulic Pump
Hydraulic Motor
Engine
Various parts
7
GB
GB
GB
Material
Steel
Steel
Steel
Poly-Ethylene
Poly-Ethylene
Steel and Aluminium
Steel
Steel and Aluminium
Steel, Aluminium & Rubber