Safety Instructions - Belle Group MINIMIX 150 Manuel De L'opérateur

Bétonnière
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

Read these safety instructions.
Please read and understand all running/safety instructions before operating this machine.
Before starting the mixer
Ensure engine oil is filled to correct level before
operating mixer. Note: The engine must be lifted to
the horizontal position when filling and checking oil.
Check that all guards are in position and correctly fitted.
DO NOT wear loose clothing or jewellery that may
become entangled in the workings of this machine.
Suitable clothing as follows should meet relevant
EEC/local safety standards: overalls, work boots,
goggles, face mask, gloves and ear defenders etc.
DO NOT tip mixer onto the drum mouth when
motor is running.
Ensure that any trailing cable is protected against
damage and not liable to be tripped over or
trapped underneath the mixer.
We recommend the use of an Residual Current
Device on 230v electrics.
Remove all packaging material before operating.
When operating the mixer
Keep unauthorised persons away from mixing drum.
Keep area around the mixer clear of obstructions
which could cause persons to fall onto moving parts.
Always ensure mixer is on level ground before mixing.
DO become familiar with the controls before
operating this machine.
DO ensure that all guards are fitted in the correct position.
Warning - Important Should the socket outlets in your home not be suitable for the plug supplied with your product, the plug
must be removed (cut-off if it is a moulded plug and disposed of) and an appropriate plug fitted. Follow wiring instructions
carefully. Do not connect either core to the earth pin, as this is a Class II Isolated Product. BLUE = NEUTRAL BROWN = LIVE
As the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings identifying the
terminals in your plug, proceed as follows: The wire which is coloured Blue must be connected to the terminal which is is
marked with the letter N or coloured Black. The wire which is coloured Brown must be connected to the terminal which is is
marked with the letter L or coloured Red.

Safety Instructions

5
DO ensure plenty of ventilation when running
diesel/petrol engines in a confined area.
DO replace any worn/damaged warning decals.
DO ensure the drum is rotating while emptying
the mixer.
DO always switch off and remove the plug from
the socket if leaving the machine unattended.
DO NOT use as a wheel barrow. Disconnect from
power supply before moving.
BEWARE of the Danger Zones & Hot Zones.
BE A WARE of exhaust venting directions.
Emergency Stop
If you have to turn off the mixer in a emergency
you must:
Electric: either turn off at switch or at the mains,
Petrol: turn the engine switch off, see engine manual.
Fire Fighting
If your mixer catches fire, turn off the electric supply.
Using a dry powder or C0
the fire. If the fire can not be put out, keep away and
call the fire brigade.
If you are in any doubt about the safety condition of
your machine, please contact your Belle authorized
Service Dealer.
MINIMIX 150 OPERATORS MANUAL
GB
fire extinguisher put out
2

Publicité

Chapitres

Table des Matières
loading

Table des Matières