Installation; Preparation - Dovre 2175CBS Installation Et Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 54

Installation

Preparation

Please check the appliance for damage caused
during transport or any damage or defects
immediately after delivery.
If you detect damage caused during transport
or any other damage or defects, do not use the
appliance and notify the supplier.
Remove the removable parts (fire-resistant inner
plates, fire compartment, fire basket, ash removal
port and ash pan) from the appliance before you
start installing the appliance.
By removing removable parts, it is easier to
move the appliance and to avoid damage.
Note the location of those removable parts, so
that you have no difficulties in installing the
parts in the right place later on.
Removing the fireproof inner plates
Remove the fireproof inner plates in the correct order
according to the instructions below.
1. Open the door by turning the latch outward and
unlocking the door; see next figure.
2. First take out the inner plates on both sides of the
appliance. In models 2175CBS3 and 2575CBS3
with the side glass, there are no inner plates.
3. Remove the left and right inner plates at the back
from the appliance.
Subject to change because of technical improvements
4. Remove the inner plate in the middle at the back
from the appliance.
Cast iron inner plates protect the combustion
chamber and dissipate heat to the
environment.
Changing the direction of the
connection collar
If you want to use a 45° connection instead of a
vertical connection, for example because it simplifies
connection to an existing flue gas duct, you have to
rotate the connection collar 180°; see the next two
figures.
1. Loosen the connection between the connection
collar and the smoke dome by unscrewing the two
M8 nuts.
2. Lift the connection collar from the two bolts.
3. Rotate the connection collar 180° and put the
collar back onto the smoke dome.
4. Connect the connection collar to the smoke dome
by tightening the two M8 nuts.
5. Use stove sealant as a seal between the
connection collar and the smoke dome.
The stove sealant is not supplied with the
appliance.
7

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

2176cbs2175cbs32576cbs2575cbs3

Table des Matières