Panasonic TY-WK85PV12 Manuel D'installation page 19

5. Install the plasma display to the wall-hanging bracket.
Insert the stand hooks (x4) on the display into the notches of the wall-hanging brackets, and lower the display
straight down.
Horizontal installation
L
Caution
When using a LAN cable for the plasma display, route the LAN cable away from the other cables (except for
the power cable).
6. Securing the plasma display.
Horizontal installation
Remove the screws (two each) for securing the unit
lock-in brackets provided on the top of the "L" and "R"
bracket units, and remove the unit lock-in brackets.
Rotate the unit lock-in brackets through 180 degrees
so that they are positioned back to front, and secure
them using the screws which were removed.
• The screws should be securely tightened to the
torque given below.
(2.5~3.5 N•m)
R
L
Caution
Be sure to tighten the left and right safety catches to prevent the display from detaching from the wall-hanging bracket.
※ After the installation, remove the eyebolt. Remove the eye bolt and insert the eye bolt cap (provided with the
plasma display).
Carefully store the removed eyebolt.
Notches (For horizontal installation)
R
Plasma display
controls
Stand hook
Safety catch
anchoring
screw
Vertical installation
Stand hook
Plasma display
controls
Vertical installation
Loosen the screws for securing the left and right unit
lock-in brackets provided on the bottom "R" of the
bracket unit.
Slide the unit lock-in brackets toward you, and
tighten the screws to secure them.
• The screws should be securely tightened to the
torque given below.
(2.5~3.5 N•m)
Notches
(For vertical installation)
Safety catch
anchoring screw
19