Replacing One Type Of Exhaust Filter With Another; When Changing The Filter Please Note; When To Change The Thread Catchers; How To Replace The Thread Lifters - Miele SBAN0 Mode D'emploi

en-US
Replacing one type of exhaust filter
with another (Fig. 07)
Depending on the model, your vacuum
cleaner will be fitted as standard with
one of the following exhaust filters :
a AirClean
b Active AirClean 30 (black)
c HEPA AirClean 30 (white)
Do not use more than one exhaust fil-
ter at a time.

When changing the filter please note

1. If you wish to replace exhaust filter a
with filter b or c, you must com-
pletely remove the filter grille before
you install the new exhaust filter.
You must also activate the
TimeStrip® exhaust filter change in-
dicator (Fig. 10).
2. If you wish to replace exhaust filter b
or c with filter a, you must insert the
new filter into a filter grille * before in-
stalling (Fig. 27).
* Filter grille – see "Optional acces-
sories"

When to change the thread catchers?

(only possible for models with a re-
versible floorhead included as standard)
The thread catchers on the suction inlet
of the reversible floorhead can be re-
placed. Check them from time to time
and replace them if the pile has worn
down.
20

How to replace the thread lifters

(Fig. 29 + 30)
 Use a suitable screwdriver to remove
the thread lifters from the slots.
 Install new thread lifters.
Replacement parts are available from
your Miele dealer or through Miele
Technical Service.

Cleaning and care


Always disconnect the vacuum
cleaner from the electrical supply be-
fore cleaning it. Turn off and unplug
it.
Vacuum cleaner and accessories
The vacuum cleaner and all plastic ac-
cessories can be cleaned with a propri-
etary cleaner suitable for plastic.

Do not use abrasive cleaning
agents, glass cleaning agents, all-
purpose cleaners or oil-based condi-
tioning agents!
Dust compartment
The dust compartment can, if neces-
sary, be cleaned using a dry duster,
brush or, if available, a second vacuum
cleaner to vacuum the dust out.
Monitor the filter bag change indicator
and inspect all filters regularly. Clean or
replace them when necessary accord-
ing to these Operating Instructions.

Do not let the vacuum cleaner
get wet. If moisture gets into the ap-
pliance, there is a risk of electric
shock.