Light Bulbs - GE Monogram ZV750 Manuel Du Propriétaire

Light bulbs

NOTE: The glass cover should be removed only
when cool.
Before replacing the bulb, disconnect electrical
power to the hood at the main fuse or circuit
breaker. Allow bulbs to cool before touching.
Be sure to let the light cover and bulb cool
completely.
For safety, do not touch a hot bulb with bare hands
or a damp cloth.
To change the light bulbs:
1. Remove the lamp lens cover by inserting a small
NOTE: Do not remove the outer trim ring (lamp
assembly).
2. Grasp the bulb and pull it straight out.
3. Using gloves or a dry cloth, remove the new bulb
4. Push the bulb straight all the way into the
5. Replace the lens cover by inserting the three
NOTE: For improved lighting, clean the glass cover
frequently using a damp cloth. This should be done
when the hood is completely cool.
6. Reconnect electrical power to the hood.
NOTE: Order replacement 120-volt, 25-watt
halogen bulb with G-9 base, WB25X10020.
These bulbs can be ordered from your GE supplier.
6
CAUTION:
flat-blade screwdriver into each of the three slots
and gently prying it free.
from the packaging. (Wearing latex gloves may
offer a better grip.) The bulb must be the same
wattage, 120-volt, 25-watt halogen with a G-9
base. Early bulb failure may occur if wattage is
too high.
receptacle.
retaining tabs into the slots and pressing into
place.
Controls and Features
Stainless Steel Hood
Use a small flat-blade screwdriver
to remove the lamp lens cover.
Tab
NOTE: Make sure the tabs are inserted
into the slots.
ONLY use a new 120-volt, 25-watt
halogen bulb with a G-9 base.
Receptacle
Use gloves
or cloth
NOTE: Do not touch the new halogen bulb
with bare fingers. Skin oils can cause early
lamp failure.
Bulb
Outer trim ring
(lamp assembly)
Do not remove
Removable inner
lamp lens cover