Electrolux EHX9565FOK Notice D'utilisation page 18

18 www.electrolux.com
Problem
The flexible induction cook-
ing area does not heat up
the cookware.
comes on.
comes on.
comes on.
Possible cause
The cookware is in the
wrong position on the flexi-
ble induction cooking area.
The diameter of the bottom
of the cookware is incorrect
for the activated function or
function mode.
Automatic Switch Off oper-
ates.
The Child Safety Device or
the Lock function operates.
There is no cookware on
the zone.
The cookware is incorrect.
The diameter of the bottom
of the cookware is too small
for the zone.
FlexiBridge function oper-
ates. One or more sections
of the function mode which
operates are not covered
by the cookware.
ProCook function operates.
Two pots are placed on the
flexible induction cooking
area.
Remedy
Place the cookware in the
correct position on the flexi-
ble induction cooking area.
The position of the cook-
ware depends on the acti-
vated function or function
mode.
Refer to "Flexible induction
cooking area" chapter.
Use cookware with diame-
ter applicable to the activa-
ted function or function
mode. Use cookware with
diameter smaller than 160
mm on a single section of
the flexible induction cook-
ing area.
Refer to "Flexible induction
cooking area" chapter.
Deactivate the hob and ac-
tivate it again.
Refer to "Daily use" chapter.
Put cookware on the zone.
Use the correct cookware.
Refer to "Hints and tips"
chapter.
Use cookware with correct
dimensions.
Refer to "Technical informa-
tion" chapter.
Place the cookware on the
correct number of sections
of the function mode which
operates or change the
function mode.
Refer to "Flexible induction
cooking area" chapter.
Use only one pot.
Refer to "Flexible induction
cooking area" chapter.