Electrolux EHX9565FOK Notice D'utilisation page 13

5.4 FlexiBridge Max Bridge
mode
To activate the mode press
see the correct mode indicator. This mode
connects all sections into one cooking
zone. To set the heat setting use one of
the left side control bars.
Correct cookware position:
To use this mode you have to place the
cookware on the four connected sections.
If you use cookware smaller than three
sections the display shows
minutes the zone switches off.
Incorrect cookware position:
until you
5.5
This function allows you to adjust the
temperature by moving the cookware to a
different position on the induction cooking
area.
The function divides the induction cooking
area into three areas with different heat
settings. The hob senses the position of
the cookware and sets the heat setting
corresponding with the position. You can
place the cookware in the front, middle or
rear position. If you place the cookware in
the front you get the highest heat setting.
You can decrease the heat setting by
moving the cookware in the middle or to
the rear position.
and after 2
General information:
• 160 mm is the minimum bottom
diameter of the cookware for this
function.
• Heat setting display for the left rear
control bar shows the position of the
cookware on the induction cooking
area. Front
ProCook function
Use only one pot when you
operate the function.
, middle
ENGLISH 13
, rear .