Transmitter Controls; Installing The Vehicle Battery - ECX Torment Manuel D'utilisation

EN
Battery Level Indicator
Solid Red and Green:
Battery voltage is
good (above 4V).
Solid Red: Battery
voltage is critically low
(below 4V). Replace
transmitter batteries.
Throttle Dual Rate
Adjusts the maximum
amount throttle the
vehicle can be given
Steering Rate
Adjusts the amount the
front wheels move when
the steering wheel is
turned left or right
Throttle Trim
Adjusts the neutral
point of the electronic
speed control
Steering Trim
Adjust to make the
vehicle drive straight
with no input at the
steering wheel
1. Turn the battery door latch counter-clockwise to
release the battery door.
2. Remove the battery door from the vehicle.
3. Connect the battery to the Electronic Speed Control
(ESC) /Receiver unit connector within the battery
compartment.
4. Install the vehicle battery pack as shown.
5. Re-install the battery door.
6. Turn the battery door latch clockwise to secure
the door.
6 TORMENT

TRANSMITTER CONTROLS

INSTALLING THE VEHICLE BATTERY

4WD 4WD
Reverse Switch
Allows you to change the direction of
steering (ST) and throttle (TH) controls.
(The default setting for steering and
throttle is "NOR")
Power Switch
Power on or off the transmitter
Steering Wheel
Control steering. Right
and Left steering with
ST switch on NOR
(See Reverse Switch)
Throttle Trigger
Controls power
to the motor for
forward or reverse
(See TH reverse
switch)
Reverse
Stop
(when TH reverse
Forward
switch on NOR)
(when TH reverse
switch on NOR)