Transmitter Controls - ECX HT-29 Manuel D'utilisation

• ECX ® Micro Roost ® Buggy (ECX00007T1/T2) or
® ®
ECX Micro Ruckus Monster Truck (ECX00008T1/T2)
• 2-CH Transmitter
• AA (4) Batteries
• 3.7V 200mAh 1S Lipo Battery (ECX10017)
Transmitter
Frequency
Battery
INSTALLING TRANSMITTER BATTERIES
This transmitter requires 4 AA
batteries.
1. Open the battery cover.
2. Install the batteries as shown.
3. Close the battery cover.

TRANSMITTER CONTROLS

1
2
3
4
5
BOX CONTENTS
SPECIFICATIONS
2415MHz-2446MHz
AA x 4
TRANSMITTER OPERATION
6
7
Truck
Power Supply
Run Time
CAUTION: NEVER remove the transmitter
batteries while the model is powered on. Loss
of model control, damage or injury may occur.
CAUTION: If using rechargeable batteries,
charge only rechargeable batteries. Charging
non-rechargeable batteries may cause the batteries
to burst, resulting in injury to persons and/or
damage to property.
CAUTION: Risk of explosion if battery is
replaced by an incorrect type. Dispose of
used batteries according to national regulations.
1. ON/OFF Switch Turns the power ON/OFF for the
transmitter
2. Bind Button Connects transmitter to vehicle
3. Indicator Light
• Green light—Indicates the transmitter is powered
on.
4. Steering Wheel Controls direction (left/right) of
the model
5. Throttle Trigger Controls speed and direction (for-
ward/brake/reverse) of the model
6. Indicator Light
• Red Charging light—Indicates the transmitter
is connected to the vehicle and is charging the
battery.
7. ST Trim Adjusts the steering center point
®
One Cell 200mAh Li-Po
10 min
3