Rear Panel And Settings - HumanTechnik AUDIOropa PRO LOOP D15 LOS Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

4.4 Rear panel and connectors
16
17 20 21 22 23
16 INPUT 1 Combo: Mic or Line input for external audio. Accepts XLR and 6.35mm jack.
17 INPUT 2: Mic or Line input for external audio. 3 port block type Phoenix input.
18 Slave input. This input is used to connect the output of another loop driver in
Master/Slave confi gurations.
19 Output to slave amplifi er. This output is used to connect the input of another loop driver
in Master/Slave confi gurations.
20 Button for line or microphone selection for INPUT 1. Switch the input according to the
source (microphone or line).
21 Phantom power feed switch. Activates the supply voltage for microphones on INPUT 1
and/or INPUT 2.
22 Button for line or microphone selection for INPUT 2. Switch the input according to the
source (microphone or line).
23 2 port block type Phoenix type input: 100V priority. This terminal block input allows to
connect an external audio input from a 100V sound system.
24 NO / NC fault relay. Allows system status information to be forwarded via a relay.
25 Master loop output »speakON« connector. Connects the inductive master loop to the
driver.
26 Slave loop output »speakON« connector. Connects the inductive slave loop to the
driver.
27 AC power cord connection.
18
19
24
25
26
27
English 25

Publicité

Table des Matières
loading

Table des Matières