Cleaning And Storage; Emptying The Dust Container - DS Produkte MC607-1 Mode D'emploi

EN

Cleaning and Storage

PLEASE NOTE!
■ Note the MAX marking on the dust container. If during use the marking is reached,
empty the dust container. The fi lters must also be regularly cleaned in order to pre-
vent overloading of the motor.
■ The dust container and all fi lters must be completely dry before they are put back
inside the device.
■ Do not use any sharp or abrasive cleaning agents or cleaning pads to clean the de-
vice. These could damage the surfaces.

Emptying the Dust Container

1. Hold the device vertically over a dustbin (if necessary detach the rod with handle
(12)). The suction opening must point downwards when you do this.
2. Press the release button for the dust container (8) and carefully remove it from the
motor unit (3).
3. Grip the HEPA fi lter (4) and pull it out.
4. Empty the dust container.
5. If necessary, the dust container can be rinsed with clear water. Then dry it thoroughly.
6. Clean the HEPA fi lter (see the "Cleaning the HEPA Filter" section).
7. Clean the motor fi lter (see the "Cleaning the Motor Filter" section).
8. Reinsert the HEPA fi lter and the motor fi lter.
9. Reassemble the motor unit and the dust container. The dust container must be heard
to engage in place.
Cleaning the Mini-Turbo Nozzle
Cleaning the HEPA Filter
The HEPA fi lter (4) should be cleaned regularly to ensure that the suction power of the
vacuum cleaner does not diminish and the motor is not overloaded.
1. Remove the HEPA fi lter from the dust container (5) (see the "Emptying the Dust
Container" section).
2. Tap out the HEPA fi lter over a dustbin. If necessary, clean it with a brush or a dry
cloth.
CAUTION! Under no circumstances should you clean the HEPA fi lter with
water! Water may damage the HEPA fi lter.
18
1. The mini-turbo nozzle can be opened to make it easy to
clean: To do this, twist the ring on the end piece of the
nozzle anticlockwise.
2. Carefully remove the upper part of the housing. Hair, dust
etc. can now be removed from the brush.
3. Put the nozzle back together after cleaning and twist the
ring clockwise to close.