Maintenance - SATA Minijet 3000 B HVLP Mode D'emploi

Operating Instructions SATAminijet 3000 B HVLP, minijet 3000 B T HVLP
EN
• Drillings must be cleaned with SATA cleaning brushes or SATA cleaning
needles only. The use of inappropriate tools could cause damage and
affect the spray pattern. Recommended accessory: cleaning kit Art.
No. 64030.
• Exclusively use spray gun washing machines recommended by SATA!
Please observe the operating instructions!
• The air passages have to be set under pressure with clean compressed
air during the entire cleaning process!
• Nozzle head has to point downwards!
• Remove the spray gun from the gun washing machine right
after the cleaning process!*
• Never use ultrasonic cleaning devices - leads to damage of noz-
zle components and gun surfaces!
• After cleaning, the spray gun, the material passages, the air
cap including thread as well as the gravity cup have to be
blown dry with clean compressed air!*
* otherwise risk of corrosion
• Check spray pattern after cleaning the nozzle set!
• Further tips concerning cleaning can be found at www.sata.com/TV.
9.

Maintenance

• Prior to maintenance, disconnect spray gun from the compressed air
circuit!
• Disassemble and assemble components very carefully! Exclusively
use included special tools!
104
Warning! Attention!
Notice!
Warning! Attention!