Using The Remote Control; Cleaning And Maintenance - Anslut 006862 Mode D'emploi

Radiateur électrique
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 75
EN

USING THE REMOTE CONTROL

The remote control has the same 6 buttons as
the control panel (MOD = MODE) and works in
the same way, with the following exceptions:
In M mode it is not possible to set the
output with the + and – buttons. Use the
oblong button on the remote control for
this.
The remote control has an ECO button for
energy save mode, where the radiator
maintains the room temperature at 16°C.
EC is shown in the display. Disable energy
save mode by pressing the ECO button
again. No other settings can be made in
this mode.
FIG. 9
NOTE:
If the start time for a timer setting is
reached when the electric radiator is in
ECO mode, the electric radiator switches
over to working according to the timer
setting.
The electric radiator does NOT return to
ECO mode at the stop time, but switches
off.
Faint sound can be heard when the
electric radiator is switched off. This is
quite normal. The sound is caused by
movement in the material when the
electric radiator cools.
MAINTENANCE
SAFETY
The electric radiator has a tilt guard,
which switches it off the electric radiator it
drops down. The electric radiator starts
again when it is put in a vertical position.
If the electric radiator is switched off the
tilt guard, switch it off with the power
switch, pull out the plug, and check that
the electric radiator is not damaged.
Do not use the electric radiator if it is
damaged or not working properly, or if
48
the power cord or plug are damaged.
Take the electric radiator to an authorised
service centre, or other qualified
personnel, to be checked and/or repaired.
The overheating protection switches off
the electric radiator if it gets too hot.
This can occur if the circulation of air
around the electric radiator is not
sufficient, for example if the electric
radiator is covered over, or placed too
near walls or other objects, or if the inlet
and/or outlet openings are blocked. The
electric radiator starts again when it has
cooled, but if the reason for the
overheating is not rectified it will overheat
again. In the event of overheating, switch
off the electric radiator with the power
switch and pull out the plug. Wait until
the electric radiator has completely
cooled, rectify the reason for the
overheating, and then use the electric
radiator as usual. If the electric radiator
overheats repeatedly without any visible
reason, switch off the electric radiator
with the power switch and pull out the
plug. Take the electric radiator to an
authorised service centre, or other
qualified personnel, to be checked
and/or repaired.

CLEANING AND MAINTENANCE

Keep the electric radiator clean. Remove dust
and dirt that can cause overheating at regular
intervals. Switch off the electric radiator,
unplug the plug and allow the electric radiator
to cool before cleaning and/or maintenance.
Cleaning
Wipe the outside of the electric radiator at
regular intervals with a damp cloth. Do
not use strong or abrasive detergents, wax
or polish.
If the electric radiator is installed on a
wall, lift it off at regular intervals and
clean behind it.
Clean the inlet and outlet grilles with a

Publicité

Table des Matières
loading

Table des Matières