Safety Instructions - Anslut 006862 Mode D'emploi

EN

SAFETY INSTRUCTIONS

• Check the product, power
cord, plug and all accessories
for any damage. Do not use
the product if any parts are
missing or damaged.
Contact the retailer.
• Do not start the product
before it is fully installed
according to the instructions.
• The product is only intended
for extra heating in the
home.
• The product has an IP24
protection rating and can be
used in bathrooms or
laundry rooms. Do not place
the product less than 1.5 m
away from sources of water
(bathtub, wash basin, toilet).
Make sure that the product
cannot drop into water, and
that water cannot get into
the product. Pull out the
plug immediately if the
product comes into contact
with water or any other
liquid.
• Do not use the product if the
power cord or plug are
40
damaged, if the product has
been in contact with water, is
not working properly, or if it
is damaged in any other way.
• Take the product to an
authorised service centre to
be checked, repaired or
adjusted.
• Never immerse the power
cord or the plug in water or
any other liquid – risk of
electric shock. Do not touch
the product, the power cord
or plug with wet hands.
• Check that the mains voltage
corresponds to the rated
voltage on the type plate.
The product must be
connected to an earthed
power point with a residual
current device that has a
maximum tripping current of
30 mA.
• Fully unwind the power cord
before use. Do not allow the
power cord to come into
contact with any part of the
heater and keep it away from
other sources of heat. Do not
lay the power cord under
carpets or where it can be