Anslut 006862 Mode D'emploi page 46

EN
6. power switch ON/OFF
• Switch on the electric radiator by pressing
the ON/OFF button. The display goes on
and the electric radiator is ready to use.
• Set the date and time. Press the SET
button until SET is shown in the display.
The numbers for the week days (row 4)
flash. Set the required week day with the
buttons + and – (1 = Monday, 2 = Tuesday
etc.) and confirm with the SET button. The
hour numbers flash. Set the hours with
the + and – buttons and confirm with the
SET button. The minutes numbers flash.
Set the minutes with the + and – buttons
and confirm with the SET button. The date
and time are now set.
NOTE:
The date and time settings are deleted if the
plug is pulled out or if the electric radiator is
switched off with the power switch, but not
if the electric radiator is switched off with the
ON/OFF button.
If no settings are made for the date and time,
use the settings for day 1 and time 00.00.
The display goes off automatically after two
minutes and goes on again when any button
is pressed.
• Select M or P mode with the MOD button.
• In M mode the buttons + and – are used
to set the required output (low, medium,
high). It is not possible to set the
thermostat.
• In P mode the buttons + and – are used to
set the required set point temperature for
the electric radiator. Low is used if the
room temperature is 1–2°C lower than the
set point temperature, Medium is used if
the room temperature is 3–5°C lower than
the set point temperature, High is used if
the room temperature is 6°C , or more,
lower than the set point temperature. The
electric radiator switches off automatically
when the set point temperature is reached
46
and switches on again when the set point
temperature drops.
• The week timer can be used in P mode.
Press the WEEK button to set or control
the week timer.
NOTE:
The date and time must be set for the week
timer to work properly.
SETTING WEEK TIMER
• Press and hold the WEEK button. 01
flashes in the display. Use the + and
– buttons to select 01 (single setting) or ][
(repeat every week). Confirm with the SET
button.
NOTE:
• Single settings (mode 01) must fall
within the present week. All single
settings (mode 01) are disabled on
Sunday (day 7) at 24.00. Settings made
on a Tuesday for Saturday work, but
settings made on a Saturday for a
Tuesday do not.
• Single settings (mode 01) are only used
once, but disabled timer settings are
stored in one of the 4 available
memories for the day in question. It can
be better to delete the setting (see
below).
• ON flashes. Select ON or OFF with the
buttons + and – to enable or disable the
preheating function. When ON is selected
the electric radiator controls the room
temperature 20 minutes before the set
time. If the temperature is 6°C, or more,
below the set point temperature the
electric radiator starts with a high output,
so that the set point temperature will be
reached before the set time. If the room
temperature is 3–5°C lower than the set
point temperature a medium output is
used, and a low output is used if the room
temperature is 1–2°C lower than the set