Anslut 006862 Mode D'emploi page 47

point temperature. Select OFF to disable
the preheating function. Confirm with the
SET button.
NOTE:
The settings for single or repeated settings
and for preheating on or off apply for all
timer settings.
• 01 SET ON is shown in the display to set
the time to start the timer setting 1. Set
the week day with the buttons + and –.
Confirm with the SET button.
• The temperature (standard setting 25°C)
flashes in the display. Set the temperature
from 0 to 37°C with the + and – buttons
and confirm with the SET button.
• The hour numbers flash. Set the hours
with the + and – buttons and confirm
with the SET button.
• The minutes numbers flash. Set the
minutes with the + and – buttons and
confirm with the SET button. The date and
time for the first start are now set.
• 01 SET OFF is shown in the display to set
the time to switch off the timer setting 1.
Make the required settings according to
the instructions above. The first timer
setting is now complete.
• 02 flashes in the display. If you want to,
do the settings for the next timer setting.
A total of 4 timer settings per day can be
made (28 per week). If no more timer
settings are to be made, wait until the
display returns to standard mode.
• Start the radiator with the ON/OFF
button. P and OFF are shown in the
display to show that a timer setting has
been made with the electric radiator
switched off. The electric radiator starts/
switches off automatically at the set time.
• The timer settings are stored even if the
plug is unplugged or if the electric
radiator is switched off with the power
switch.
• Press the WEEK button repeatedly to show
the timer settings in the following order:
1. Single or repeated setting
2. Preheating on/off
3. Thermostat setting
4. Time to start
5. Time to stop
6. Next timer setting
• To delete a timer setting, press and hold
the WEEK button and then go to the
required timer setting. Go past 01- ][ and
ON/OFF by tapping the button SET. When
the number for the required timer setting
is shown, press the SET until a short audio
prompt indicates that the setting is
deleted.
• Press and hold the WEEK button to delete
all timer settings. Press and hold the MOD
and SET buttons until an audio prompt is
given. The display shows 88:88 to
indicate that all the settings have been
deleted.
NOTE:
It is not possible to delete all the timer
settings with the remote control, only with
the buttons on the control panel.
• To disable timer settings without deleting
them, press and hold the WEEK button
and then the MOD button until TIME goes
off the display, to show that the settings
are stored but not enabled. Enable the
timer settings again by pressing the MOD
button until TIME is shown in the display.
IMPORTANT:
If no buttons are pressed within two minutes
the LED display goes off, but ON is still
shown. The display goes on again when any
button is pressed. If the electric radiator is
switched off with the ON/OFF button, OFF is
shown in the display.
EN
47