Diamond Blades - Husqvarna K 1270 II Manuel D'utilisation

vibrations continue, replace the cutting
blade.
Bonded abrasive cutting blades
WARNING:
abrasive cutting blades together with water.
Moisture decreases the strength in the
bonded abrasive cutting blade and the
cutting blade can break and cause injury.
A bonded abrasive cutting blade is made of small
abrasive grains joined with an organic or vitrified bond,
molded with fabric reinforcements, which prevents the
cutting blade from breaking during high speed operation.
Bonded abrasive cutting blades for different
materials
Note:
Make sure that you use the correct cutting
blades for rail cutting.
Blade type Material
Concrete Concrete, asphalt, stone masonry,
blade cast iron, aluminum, copper, brass,
cables, rubber and plastic.
Metal blade Steel, alloy steel and other hard met-
al.
Cutting blade Rail
for rail cutting
To examine a bonded abrasive cutting blade
• Make sure that there are no cracks or damages on
the cutting blade.
14
Do not use bonded
• Hang the cutting blade on your finger and hit the
cutting blade lightly with a screwdriver. If you do not
hear a clear sound, the cutting blade is damaged.

Diamond blades

WARNING:
very hot when used. A diamond blade that is
too hot gives bad performance, blade
damage and is a safety risk.
WARNING:
blades to cut plastic material. The hot
diamond blade can melt the plastic, which
can cause a kickback.
• Diamond blades have a steel core with segments
that are made of industrial diamonds.
• Diamond blades are used for masonry, reinforced
concrete and stone.
• Make sure that the diamond blade rotates in the
direction of the arrows shown on the diamond blade.
• Always use a sharp diamond blade.
• Diamond blades can become blunt if you use an
incorrect feeding pressure or when you cut materials
such as hard reinforced concrete. If you use a blunt
diamond blade it becomes too hot, which can cause
the diamond segments to come loose.
To sharpen the cutting blade
Note:
For the best cutting results, use a sharp cutting
blade.
• To sharpen the cutting blade, cut into soft material,
such as sandstone or brick.
xxxx
Diamond blades become
Do not use diamond
1631 - 001 - 04.05.2021