Operating Instructions; Warranty - Belle Group ALTRAD EASY SCREED 200 Manuel De L'opérateur

GB
WARNING
D
Fitting the rule
1. Place the rule on the À oor.
2. Position the engine unit over the rule.
3. Insert bolts (A) and À at washers (B), then toothed washers (C) and nuts (D).
4. Tighten the bolts (A) with the spanner supplied.
Operation
1. Level in the usual way, pour on the concrete and place your rule at the start of the ¿ rst strip.
2. Fit the shaft to the motor block.
3. Before starting, spray diesel or shuttering oil on the rule to prevent it sticking to the concrete.
4. Start the machine.
5. Adjust the vibration to suit the À uidity of the concrete.
6. Place the bar on your shoulder and rotate it to tilt the rule backwards or forwards.
7. Pull slowly towards you.
8. Repeat, if necessary.
9. When smoothing the following strip, position the rule so that it overlaps the area already smoothed by 15 cm.
GB
Your new Belle Group 'Easy Screed 200' is warranted to the original purchaser for a period of one-year (12 months) from the original
date of purchase. The Belle Group warranty is against defects in design, materials an workmanship.
The following are not covered under the Belle Group warranty:
1. Damage caused by abuse, misuse, dropping or other similar damage caused by or as a result of failure to follow assembly,
operation or user maintenance instructions.
2. Alterations, additions or repairs carried out by persons other than Belle Group or their recognised agents.
3. Transportation or shipment costs to and from Belle Group or their recognised agents, for repair or assessment against a warranty
claim, on any machine.
4. Materials and/or labour costs to renew, repair or replace components due to fair wear and tear.
The following components are not covered by warranty:
• Drive belt(s)
• Engine air ¿ lter
• Engine spark plug
Belle Group and/or their recognised agents, directors, employees or insurers will not be held liable for consequential or other damages,
losses or expenses in connection with or by reason of or the inability to use the machine for any purpose.
Warranty Claims
All warranty claims should ¿ rstly be directed to Belle Group, either by telephone, by Fax, by Email, or in writing.
For warranty claims:
Belle Group Warranty Department,
Unit 5, Bode Business Park
Ball Haye Green
Leek, Staffordshire
ST13 6BW.
England.
Tel : +44 (0)1538 380000

Operating Instructions

Before you operate or carry out any maintenance on this machine YOU MUST READ and STUDY
this manual.
Fax : +44 (0)1538 380038

Warranty

Email : warranty@belle-group.co.uk
8