Replacing The Ac Fuse; Replacing The Dc Plug Fuse; Replacing The Light Pcb - Dometic CFX28 Notice D'utilisation

Operation
7.13

Replacing the AC fuse

D
DANGER! Danger of electrocution!
Disconnect the power supply and the connection cable before you
replace the device fuse.
➤ Disconnect the power supply to the device.
➤ Pull off the connection cable.
➤ Pry out the fuse insert (fig. 4 2, page 4) with a screwdriver.
➤ Replace the defective glass fuse with a new one that has the same type and rating
(4 A, 250 V).
➤ Press the fuse insert back into the housing.
➤ Reconnect the power supply to the device.
7.14

Replacing the DC plug fuse

➤ Unscrew the contact pin housing (fig. 8 3, page 6) from the plug (fig. 8 1,
page 6).
➤ Replace the defective fuse (fig. 8 2, page 6) with a new fuse of the same type
and rating (3AG, Fast Acting, 10 A).
➤ Re-assemble the plug in reverse order.
I
NOTE – Internal DC fuse
There is an additional DC fuse inside the device (Automotive standard
blade fuse, 10 A). This fuse can only be replaced by an authorised repair
centre.
7.15

Replacing the light PCB

➤ Disconnect the power supply to the device.
➤ Pry out the transparent cover with a screwdriver (fig. 9 1, page 6).
➤ Unscrew the PCB mounting screws (fig. 9 2, page 6).
➤ Pull out the plug from the PCB (fig. 9 3, page 6).
➤ Replace the defective light PCB with a new one.
➤ Fit new PCB using reverse of removal instructions.
➤ Press the transparent cover back into the housing.
22
CFX28 – CFX65W
EN