Product Information - Graco EverSure Manuel D'utilisation

IMPORTANT
EN
READ THESE INSTRUCTIONS
CAREFULLY BEFORE USE AND KEEP
THEM FOR FUTURE REFERENCE.
YOUR CHILD'S SAFETY MAY BE
AFFECTED IF YOU DO NOT FOLLOW
THESE INSTRUCTIONS.
WARNING:
IMPORTANT, RETAIN FOR FUTURE
REFERENCE: READ CAREFULLY.
NO booster can guarantee full
protection from injury in an accident.
However proper use of this booster
will reduce the risk of serious injury or
death to your child.
Always take care to follow the
installation instructions correctly, this
will ensure the booster performs at
an optimum safety level.
Do take care so that the rigid items
and plastic parts of an booster shall
be so located and installed that they
are not liable to become trapped by
a moveable seat or in a door of the
vehicle.
To use this booster seat according
to the ECE R129/03, your child must
meet the following requirements.
Child height 100cm-150cm
(reference age: 3.5-12 years).
Forward facing only (in vehicle travel
direction)
The booster may not fit to all vehicles
for the usage from 135cm-150cm.
Any straps holding the booster to
the vehicle should be tight and the
straps should not be twisted.
The booster seat should be replaced
if it has been subjected to heavy
loads in the event of an accident or if
it has been dropped.
This booster seat is only intended to
be used in the car.
Do not make any alterations or
additions to the booster seat without
approval from the type approval
authority. DO NOT remove any of the
white EPP/EPS foams. Failure to do so
may result in serious safety issues.
DO NOT use the seat if the surfaces
are too hot from sunlight.
Never leave the child unattended in
the booster seat or vehicle, not even
for a few minutes.
Any luggage or other objects liable
to cause injuries in the event of a
collision shall be properly secured.
The booster shall not be used
without the soft goods.
The booster soft goods should not be
replaced with any other than the one
recommended by the manufacturer,
because the soft goods constitutes
an integral part of the restraint
performance.
7
Always secure child in booster, even
on short trips, as this is when most
accidents occur.DO NOT leave this
booster, or other items unbelted or
unsecured in your vehicle. Remove
the booster seat from the car if not
regular used and store in a dry, sun-
protected surrounding.
It's recommended not to use a
second-hand booster seat whose
history is not known. It may have
invisible structural damages or
defects due to incorrect usage/
storage.
DO NOT use any load bearing
contact points other than those
described in the instructions and
marked on the booster.
DO NOT install this booster under the
following conditions:
1. Vehicle seats facing sideways
or rearward with respect to the
vehicle's direction of travel.
2. Vehicle seats movable during
installation.
Consult the retailer for issues
concerning maintenance repair and
part replacement.
To avoid burns, never put hot liquids
in your booster's cupholders.
Product
Information
1. This is an Enhanced Child Restraint
System, intended to use as a Non-
integral Universal Enhanced Child
Restraint System (i-Size booster
seat) from 100-150cm.
2. It is approved to the latest UN
Regulation R129/03.
Product Booster seat
Materials Plastics, Metal, Fabrics
Patent No. Patents pending
Suitable for Child height 100cm-
150cm (Reference age
3.5-12 years).
Installation Forward facing (in
vehicle travel direction)
Booster Assembly
1 5
See images -
1
Squeeze the head support
adjustment lever first and then
slide in lower back support
under the fabric cover to
connect them together.
! CHECK to make sure two pieces
are securely snapped together
by pulling on them.
2
To attach the lower back support
to the base, hook the lower back
support over the seat bar hinge
on the base.
8