DeWalt DWE6401DS Guide D'utilisation page 11

Masquer les pouces Voir aussi pour DWE6401DS:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

adjusted. The speed control dial adjusts the rotation speed of the pad
from approx. 0 to 3700 rpms.
TRIGGER SWITCH
As the trigger switch is pressed in, the rotation continues to increase,
but will not exceed the maximum setting on the speed control dial.
As the trigger is released, the sander head revolutions per minute are
reduced.
Proper Hand Position (Fig. 7)
WARNING: To reduce the risk of serious personal injury, ALWAYS
use proper hand position as shown.
WARNING: To reduce the risk of
serious personal injury, ALWAYS hold
securely in anticipation of a sudden
reaction.
Proper hand position requires one
hand under the main handle (A) and
the other hand on the side handle (B).
Dust Collection (Fig. 1)
WARNING: To reduce the risk
of injury, turn unit off and disconnect it from power source
before installing and removing accessories, before adjusting
or when making repairs. Be sure the switch is in the "OFF" position.
An accidental start-up can cause injury.
WARNING: To reduce the risk of serious personal injury, NEVER
operate this tool with perforated paper unless the dust collection
system is in place.
WARNING: Empty dust collection system frequently, especially
when sanding resin-coated surfaces such as polyurethane, varnish,
shellac, etc. Dispose of coated dust particles according to the finish
manufacturer's guidelines, or place in a metal can with a tight fitting
metal lid. Remove coated dust particles from the premises daily.
The accumulation of fine sanding dust particles may self ignite and
cause fire.
Attach vacuum hose to the dust port (D).
Using the Sander (Fig. 7)
To operate your sander, grasp it as shown in Figure 7. Hold the tool
firmly and turn it on. Apply the sanding disc to the workpiece and
apply slight pressure only. Be sure to check your work often. This
sander is capable of removing material rapidly, especially with coarse
paper.
To produce the best finish possible, start with coarse grit sandpaper
FIG. 7
and change gradually to finer and finer paper. Vacuum and wipe the
A
surface with a tack cloth between grit steps.
When sanding painted surfaces (see Additional Safety Rules for
Paint Removal), you may find that the sandpaper clogs with paint.
A heat gun will work much better to remove paint before sanding.
Follow all the safety instructions in the heat gun instruction manual.
B
MAINTENANCE
and disconnect it from power source before installing and
removing accessories, before adjusting or when making
repairs. An accidental start-up can cause injury.
Cleaning
at least once a week. To minimize the risk of eye injury, always wear
ANSI Z87.1 approved eye protection when performing this.
cleaning the non-metallic parts of the tool. These chemicals may
weaken the plastic materials used in these parts. Use a cloth
9
WARNING: To reduce the risk of injury, turn unit off
WARNING: Blow dirt and dust out of all air vents with clean, dry air
WARNING: Never use solvents or other harsh chemicals for

Publicité

Table des Matières
loading

Table des Matières