Security Check - GYS SPOT LIFT PRO Mode D'emploi

MADE IN FRANCE
Check and lubrication points :
N° Description
1 Scissor axis (L/R)
2 Plate axis (L/R)
3 Interface of the 2 scissors
4 Internal chisel slide
5 Fixed axis external scissors
6 Bellows

SECURITY CHECK

Security screening is required for the SPOT LIFT PRO operational security guarantee.
It must be done at regular intervals:
Use of the «Regular safety check (page 14)» form.
Make a copy of the SPOT LIFT PRO status report and attach it to the operating instructions.
Regular safety checks must be carried out by an authorised person. It is recommended to perform maintenance simul-
taneously.
TROUBLESHOOTING, CAUSES, SOLUTIONS
The table below shows the anomalies that can be observed when using the jack. If the problem is not listed in the
table below, stop using the tool and contact your dealer immediately for instructions.
TROUBLESHOOTING
The joystick is activated, but the jack
does not lift high enough to insert
the safety supports.
Air leaks during the lifting.
SPOT LIFT PRO
4
6
Lubrication and control points
Désignation:
SPOT LIFT PRO - V2
• Check that the lock nuts are securely fastened
Produit:
• Lubricate the shafts
Nom du chier CAO:
• Lubricate the rubbing parts
• Check that the circlip is securely fastened
• Lubricate the axle and slide
• Check the bellows for damage
• Check the tightness of the screws of the top and bottom plate fixing
• Treat the surface of the bellows with a suitable rubber care product
CAUSES
Excessive charge
Insufficient air pressure for the
charge.
Air pressure too important
Security valve faulty
2 3 2
2 1 2
Assemblage
Check the weight of the vehicle.
Rated load < or = at 1300 kg.
Check that the air supply is set to a
maximum of 5.5 bar.
Set the air pressure to max. 5.5
bar using a pressure regulator (not
supplied).
Replace the safety valve
5
6
Etabli par: Mickaël TEXIER Statut:
Études
Date: 16/02/2018
053557
Indice: Feuille:
A 1/1
SOLUTIONS
EN
17