Background Information; Limitations Of Liability; Intended Use - GYS SPOT LIFT PRO Mode D'emploi

MADE IN FRANCE
Thank you for choosing GYS In order to gain maximum satisfaction from your SPOT LIFT PRO and for your safety, please
read this manual carefully before first use and keep it carefully for future reference.

BACKGROUND INFORMATION

This operating manual contains important information for the installation in order to ensure proper and safe commis-
sioning and to ensure the safe operation of the jack. Complying with the documentation reduces risks and extends the
life of the product. This manual contains a form to certify regular safety checks. Use the «Regular Safety Check (page
14)» form to archive the checks. (It is advisable to make a copy of the form before completing it for the first time or
to download it from our website.)
Installation and control:
Work ensuring safety and security controls are reserved exclusively for specially trained persons. These persons are
referred to in this documentation as experts and/or skilled persons.

LIMITATIONS OF LIABILITY

The SPOT LIFT PRO is a movable pneumatic jack designed in compliance with standards. All data and advice in this
manual have been collected in accordance with its applicable standards and regulations and our extensive knowledge
and experience.
GYS cannot be held liable for any material or bodily damage that may result in death by:
- Non-compliance with the operating instructions
- Improper or dangerous use
- Employment of unskilled persons
- Unauthorized modification
- Insufficient maintenance

INTENDED USE

The SPOT LIFT PRO is intended for the repair of passenger cars. The jack allows the bodybuilder to safely lift either the
front or rear part of the vehicle. The nominal load capable of being lifted over the entire jack stroke is «see technical
table (page 2)».
The jack may only be used by persons who have read and understood the operating instructions.
A safety perimeter must be defined in which no one must be present during the lifting operation (minimum 2m around
the vehicle to allow escape if necessary).
The lifting of people or other objects is not allowed. No one must be inside the vehicle to be lifted.
The jack must be used inside a work area and protected from bad weather (wind, rain and extreme temperature).
The operating temperature range is between 5°C and 60°C maximum. In case of prolonged storage in a place where
the temperature is below 0°C, allow at least 12 hours before use by storing it in the workplace.
Do not use in excessively humid conditions. The device must not be submerged. Water getting inside the device may
damage the pneumatic system.
The pneumatic system must be equipped with a moisture filter (not supplied with the jack).
Never use the lift on uneven surfaces / slopes. The ground must be flat and strong enough to prevent the wheels from
sinking under the weight of the load.
It is forbidden to use the jack on a boat/ship (stability problem).
Do not lift a load greater than the permissible load of the jack noted on the rating plate «see technical table (page 2)
or rating plate on the jack».
Clean the support surface of the vehicle and the rubber pads of the jack properly before each use. Remove any grease
and oil stains that may cause the vehicle to slide.
SPOT LIFT PRO
EN
11