GE IM-4A Manuel D'utilisation Et D'installation page 4

Before you call for service...
Troubleshooting Tips
Save time and money! Review the following chart first
and you may not need to call for service.
Problem
Automatic icemaker
does not work/'not
4
Possible Causes
Freezer compartment
too warm.
Icemaker is not turned on.
Icemaker is not plugged
in correctly.
Water line kinked.
Water supply turned off or
not connected.
Piled up cubes in the storage bin
cause the icemaker to shut off.
Water valve is not plugged in
correctly.
What To Do
• After installing the kit, allow the refrigerator to completely
cool down for 24 hours. Once the compartment is cool, the
icemaker will begin ice production.
• Move the icemaker
power switch to the
Power
I (on) position.
Switch
The indicator light
below the switch Green
Indicator
will turn green.
Light
• If using a power cord adapter, make sure that it is fully
connected. Also check that the icemaker cord plug is fully
inserted into the socket. See Plug in the icemaker. When the
icemaker is turned on, the green power indicator light
below the switch will turn on.
Hook
• Check that the plastic water
line running from the valve
to the water tube inlet is not
kinked. See Connect the
water line. A kink in the
water line will restrict flow
to the water line.
• After installing the kit, make sure the house water supply
to the refrigerator has been turned on.
• Level cubes by hand.
• Check that the valve wire
adapter is completely
plugged onto the male
connector plug and the
terminals on the water valve.
See Attach the water valve.
Icemaker
Feeler Arm
Locking
Tabs
Clip
Restraints
onto
Locking
Tabs
Adhesive-backed
Fasteners for
Water Tube
Male
Connector
Plug
Valve
Terminals