Kinetec Performa Manuel D'utilisation page 15

Electrical connection: SAFETY FIRST.
The KINETEC Performa is type B, class I devices.
Before connecting the device to the power supply, check that the mains voltage
matches that shown on the identification plate (100-240 V~ 50-60Hz).
Connect the power supply cable (21).
IMPORTANT
Check that the electrical socket is in good condition and is suitable for the splint
power supply cord. The latter complies with current standards and has a
grounding socket.
The plug may be connected to any standard socket.
The socket must however have a grounded pin.
To connect the power supply, only use the original cable supplied with the
machine.
Check that the cables remain free around the device so that they do not get
damaged.
Check that the machine is not damaged, in particular the protective housings.
Starting the unit
Switch on the unit (9). The display comes on and then the display shows:
Your KINETEC Performa is ready to be used.
START/STOP/REVERSE function
As with all KINETEC systems, KINETEC Performa is equipped with a START/STOP/REVERSE function.
Press the STOP key of the hand control. The movement stops,
Press the START key of the hand control. The movement starts in the opposite direction.
For optimum safety, always give the hand control to the patient before starting the system.
Procedure to stop the machine:
To stop the machine's movement: Press the STOP button.
To switch power off: press the ON / OFF switch (9).
Locking the hand control setting
The hand control allows the patient to control the machine as appropriate.
UNLOCKED POSITION (22) adjustments are possible.
LOCKED POSITION (22) the OPERATIONAL settings can be read and the
Start/Stop/Reverse function operated.
Double Blocage :
Simultaneously press the PAUSE EXT and PAUSE FLEX keys to lock the hand control, The display reads
LOCK, you cannot change the parameters, if you try the display reads VERROU SOFT . To unlock the
hand control, simultaneously press the same keys, The display reads UNLOCK.
We recommend that you lock the hand control when you give it to the patient.
Note: The hand control locking is preserved when you switch the unit ON/OFF.
Performa
Caution:
EN
21
KINETEC PERFORMA
22
9
3/10