Disposal - Hilti DX 460 GR Mode D'emploi

Fault
Stud breaks
en
Stud head penetrates through
material fastened

10. Disposal

Most of the materials from which Hilti power actuated tools are manufactured can be recycled. The materials
must be correctly separated before they can be recycled. In many countries, Hilti has already made arrange-
ments for taking back your old powder actuated tools for recycling. Please ask your Hilti customer service
department or Hilti sales representative for further information.
Should you wish to return the power actuated tool yourself to a disposal facility for recycling, proceed as fol-
lows: Dismantle the tools as far as possible without the need for special tools.
Separate the individual parts as follows:
Part / assembly
Toolbox
Outer casing
Screws, small parts
Used cartridge strip
12
Printed: 12.08.2013 | Doc-Nr: PUB / 5069839 / 000 / 02
Cause
■ Driving power too low
■ Application limit exceeded
(very hard surface)
■ Driving power too high
O.K.
Possible remedies
■ Try higher power setting or
■ Switch to more powerful system
■ Where permissible for the
■ Reduce power setting
■ Use lighter cartridge
Main material
Plastic
Plastic / synthetic rubber Plastics recycling
Steel
Plastic / steel
heavier cartridge
like DX 76 PTR
application: predrill or change to
a different system (X-BT)
(please contact your Hilti sales
representative for further infor-
mation)
Recycling
Plastics recycling
Scrap metal
According to local regulations