Technical Data; Safety Instructions; Basic Information Concerning Safety; Proper Organization Of The Work Area - Hilti PP 10 Mode D'emploi

4 Technical data

Right of technical changes reserved.
NOTE
Right of technical changes reserved.
Wavelength, PP 10
en
Wavelength, PP 11
Accuracy
Laser class: class 3R
Laser class: class IIIa
Laser beam diameter
Self-leveling range
Inclination range
Min. inclination setting
Battery life (PP10)
Battery life (PP11)
Operating temperature range
Storage temperature range
Water and dust resistant
Weight (including 4 batteries)
Dimensions (∅)
Automatic target plate recognition
Range

5 Safety instructions

5.1 Basic information concerning safety

The tool is designed to be used for determining, transfer-
ring or checking alignment in the horizontal and inclined
planes.
In addition to the information relevant to safety given in
each of the sections of these operating instructions, the
following points must be strictly observed at all times.
5.2 Misuse
a) The tool and its ancillary equipment may present
hazards when used incorrectly by untrained per-
sonnel or when used not as directed.
b) To avoid the risk of injury, use only genuine Hilti
accessories and additional equipment.
c) Modification of the tool is not permissible.
d) Observe the information printed in the operat-
ing instructions concerning operation, care and
maintenance.
e) Do not render safety devices ineffective and do
not remove information and warning notices.
f) Keep laser tools out of reach of children.
16
633 nm
532 nm
Temperature +24°C (75°F), Horizontal distance 10 m
(33 ft): -0.5...0.5 mm (¹⁄₅")
As perIEC 825‑ 1:2003
As perCFR 21 § 1040 (FDA)
12 mm (¹⁄₂")
-10...10%
-15...40%
0.001%
Temperature +20°C (+68°F), Alkaline manganese: 70 h
Temperature +20°C (+68°F), NiMH: Min. 48 h
Temperature +20°C (+68°F), Alkaline manganese: 45 h
Temperature +20°C (+68°F), NiMH: Min. 32 h
-20...+50°C (-4 to 122°F)
-30...+60°C (-22 to 140°F)
Depth of submersion 5 m (15 ft), Duration of submer-
sion 24 h: Yes
3.8 kg (8 lbs 6 oz)
Without grip: 122 mm (4 ⁴⁄₅") x 330 mm (13")
5...150 m (15 to 500 ft)
g) Failure to follow the correct procedures when open-
ing the tool may cause emission of laser radiation in
excess of class 3. Have the tool repaired only at a
Hilti service center.
h) Take the influences of the surrounding area into
account. Do not use the tool where there is a risk
of fire or explosion.
i) (Statement in accordance with FCC §15.21):
Changes or modifications not expressly approved
by the manufacturer can void the user's authority to
operate the equipment.

5.3 Proper organization of the work area

a) Secure the area in which you are working and
take care to avoid directing the beam towards
other persons or towards yourself when setting
up the tool.
b) Measurements taken through panes of glass or other
objects may be inaccurate.
c) Ensure that the tool is set up on a steady, level
surface (not subject to vibration).