Basic Principle; Control Panel; Items Supplied; Accessories - Hilti PD 5 Mode D'emploi

All manuals and user guides at all-guides.com

2.4 Basic principle

The distance is measured along a laser beam emitted by
the tool to the point at which the beam strikes a reflective
surface. The target from which the measurement is taken
is clearly identified by the red laser measuring spot. The
range of the tool depends on the reflectance and structure
of the target surface from which measurements are taken.

2.5 Control panel

On/off button When the tool is switched off, press
the button briefly to switch it on.
When the tool is switched off, press and
hold the button to activate the menu.
When the tool is switched on, press the
button briefly to switch it off.
Measure button Quick start (When the tool is switched
off: Press the button briefly - the tool
switches on and activates the laser).
Begins distance measurement.
Activates the laser beam.
Activates continuous measuring mode
(long press, approx. 2 sec.).
Stops continuous measuring mode.

2.6 Items supplied

1 PD 5 laser range meter
2 Batteries
1 Soft pouch
1 Operating instructions
1 Manufacturer's certificate

3. Accessories

Not supplied with the tool.
Target plate PDA 50 with reflective coating
(4.7×5.1 in)
PDA 51 (4.7×5.1 in)
PDA 52 with reflective coating
(8.3×11.7 in)
Laser visibility glasses PUA 60

4. Technical data

Right of technical changes reserved.
Power supply
2×1.5 V, type AAA batteries
Battery condition check
Battery condition indicator with 4 segments showing
100%, 75%, 50%, 25% charge :
No segments shown: The batteries are exhausted
en
3