Fcc Statement / Ic Statement - Hilti PD 5 Mode D'emploi

All manuals and user guides at all-guides.com
For repair or replacement, send tool or related parts imme-
diately upon discovery of the defect to the address of the
local Hilti marketing organization provided.
This constitutes Hilti's entire obligation with regard to war-
ranty and supersedes all prior or contemporaneous com-
en
ments and oral or written agreements concerning warranties.

12. FCC statement / IC statement

-CAUTION-
This equipment has been tested and found to comply with
the limits for a class B digital device, pursuant to part 15 of
the FCC rules. These limits are designed to provide reason-
able protection against harmful interference in a residential
installation. This equipment generates, uses, and can radi-
ate radiofrequency energy and, if not installed and used in
accordance with the instructions, may cause harmful inter-
ference to radio communications.
However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which
can be determined by turning the equipment on and off, the
user is encouraged to try to correct the interference by one
or more of the following measures:
• Re-orient or re-locate the receiving antenna.
• Increase the distance between the equipment and receiver.
• Connect the equipment to an outlet on a circuit different
from that to which the receiver is connected.
• Consult the dealer or an experienced TV/radio technician
for assistance.
-NOTE-
Changes or modifications not expressly approved by the
party responsible for compliance could void the user's author-
ity to operate the equipment.
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
1) this device may not cause harmful interference, and
2) this device must accept any interference received, includ-
ing interference that may cause undesired operation.
This device complies with the requirements defined in RSS-
210 of IC.
Operation is subject to the following two conditions:
1) this device may not cause harmful interference, and
2) this device must accept any interference received, includ-
ing interference that may cause undesired operation.
12