Explanation Of The Pictograms And Other Information; Description; Intended Use; Display Illumination - Hilti PD 5 Mode D'emploi

All manuals and user guides at all-guides.com
1.2 Explanation of the pictograms and other
information
Warning signs
en
General
warning
Symbols
Read the Temperature
operating indicator
instructions
before use.
Battery status Hardware
indicator errors
1.3 Location of identification data on the range meter
The type designation and serial number can be found on the
rating plate on the back side of the range meter. Make a note
of this data in your operating instructions and always refer
to it when making an enquiry to your Hilti representative or
service department.
Type:
Serial no.:

2. Description

2.1 Intended use

The range meter is designed for the:
• Measurement of distances
2.2 Display
The measurements, settings and tool status are shown in
the display. When the tool is in measuring mode, the mea-
surements taken are shown at the bottom of the display
area (the result line).

2.3 Display illumination

In low light conditions, the display is illuminated automat-
ically as soon as a button is pressed. If no button is pressed
over a period of 20 seconds, the display illumination switches
off automatically.
2
Symbols
LASER RADIATION - DO NOT
STARE INTO BEAM
620-690nm/0.95mW max.
CLASS II LASER PRODUCT
Laser class II according
to CFR 21, § 1040 (FDA)
>1/4s
2
Do not look Laser class 2 Return waste
into the beam. material for
recycling.
Unfavorable KCC-REM-
operating HLT-PD5
conditions