Technical Notes - Komet KUB Centron Powerline Mode D'emploi

KOMET KUB Centron® Powerline

Technical notes

1. Starting on uneven surfaces (cast surfaces)
• Possible in principle
• Reduce feed rate when starting bore
2. Starting on angled surfaces
• Surface for starting bore must be spot faced beforehand
• Avoid chip jams on drill shank
3. Angled bore exit
• Possible under certain conditions
• Reduce feed rate if necessary
• Drilling angle max. 3°
4. Starting on cambered surfaces
• Centered boring can be started with reduced feed rate
• Spot facing is required if the point for starting the bore
is outside the radius centre
5. Drilling through a cross bore
• Halve feed rate at interruption
• Cross bore max. 1/3 of bore diameter
• Off-centre cross bore not possible
6. Starting on a groove or large centering bore
• Surface for starting bore must be spot faced beforehand
• Reduce feed rate if necessary
24
Please see notes on safety (page 19)!