Replacing The Plug Fuse (12/24 V); Cleaning And Maintenance; Warranty - Dometic CoolFreeze CDF11 Notice D'utilisation

CoolFreeze CDF11
6.12

Replacing the plug fuse (12/24 V)

➤ Pull the adapter sleeve (fig. 3 4, page 4) off of the plug.
➤ Unscrew the screw (fig. 3 5, page 4) out of the upper half of the housing
(fig. 3 6, page 4).
➤ Carefully raise the upper half of the housing from the lower (fig. 3 1, page 4)
half.
➤ Take out the contact pin (fig. 3 3, page 4).
➤ Replace the defective fuse (fig. 3 2, page 4) with a new one that has the same
rating (T8A 32V).
➤ Re-assemble the plug in the reverse order.
7

Cleaning and maintenance

A
NOTICE! Damage hazard
• Never clean the cooler under running water or in dish water.
• Do not use abrasive cleaning agents or hard objects during cleaning
as these can damage the cooler.
➤ Occasionally clean the device interior and exterior with a damp cloth.
➤ Make sure that the air inlet and outlet vents on the device are free of any dust and
dirt, so that heat can be released and the device is not damaged.
8

Warranty

The statutory warranty period applies. If the product is defective, please contact the
manufacturer's branch in your country (see dometic.com/dealer) or your retailer.
For repair and warranty processing, please include the following documents when
you send in the device:
• A copy of the receipt with purchasing date
• A reason for the claim or description of the fault
EN
Cleaning and maintenance
17