Dometic CoolFreeze CDF11 Notice D'utilisation page 13

CoolFreeze CDF11
6.5 Switching-on the cooler
A
NOTICE! Danger of damaging the device!
• Ensure at all times that there is sufficient ventilation so that the
heat that generated during operation can dissipate. Ensure that
the ventilation slots are not covered. Make sure that the device
is sufficiently far away from walls and other objects so that the air can
circulate.
• Ensure that the only those objects are placed in the cooler that are
intended to be cooled at the selected temperature.
• Disconnect the cooler and other consumer units from the battery
before you connect the battery to a quick charging device.
Overvoltage can damage the electronics of the device.
• For protection of the device the DC cable supplied includes a fuse
inside the plug. Do not remove the fused DC plug. Only use the DC
cable supplied.
The cooler can be operated with 12 V or 24 V
For safety reasons the cooler is equipped with an electronic system to prevent
polarity reversal. This protects the cooler against short-circuiting when connecting to
a battery.
➤ Place the cooler on a firm foundation.
Make sure that the ventilation slots are not covered and that the heated air can
dissipate.
➤ Plug the DC connection cable into the DC voltage socket of the cooler.
➤ Connect the connection cable to the DC power outlet.
I
NOTE
During normal operation the emergency switch (fig. 1 12, page 3) has
to be set to the "Normal" position.
➤ Press the "ON/OFF" button (fig. 2 1, page 3) for three seconds.
✓ The "POWER" LED (fig. 2 2, page 3) lights up green.
When the cooler reaches the preset temperature, the LED lights up orange.
✓ The display (fig. 2 5, page 3) switches on and shows the current cooling
temperature.
✓ The cooler starts cooling the interior.
EN
g
.
Operation
13