Using The Feed Unit On Ajointer Planer - Maggi STEFF 2034 Mode D'emploi

4-6 ROLLERS
The 4-6 rollers STEFF Feed unit must
be so positioned that the toupie miller
is immediately after the input rollers (A)
and (B).
3 ROLLERS
3-9 USING THE FEED UNIT ON
A JOINTER PLANER
When a 3-rollers STEFF Feed unit is
fitted on a jointer planer, all Feed unit
rollers must act on the outgoing side of
the planer. The entry roller (A) must be
approximately 5-6 cm from the
workstand opening. The pressure of the
rollers on the piece to be machined
must be as light as possible.
4-6 ROLLERS
The same indications apply to a 3-roll-
ers Feed unit, can be applied to a 4-6
rollers STEFF Feed unit.
UK
21