Hendi 231852 Mode D'emploi page 6

4.2. ASSEMBLING THE DISCS
Lift up the locking handle as shown in figure no. 1
And open the cover. Remove the ejector and place
appropriate disc. Close the cover. Push the start
Opening the cover (figure no. 1)
4.3. DISCS – STANDARD EQUIPMENT
EN
Shredding discs
Slicing discs
4.4. USING THE DISCS
The device is supplied with the ejector fitted to the
drive spindle. Release the cover lock and lift the
cover to remove the ejector (see figure. 1)
Before starting work always check the cleanliness
of the cutting chamber, the drive spindle, the ejec-
tor and the cutting discs.
1) Slicing, shredding and grating
• Mount the ejector onto the flat surface of the
drive spindle.
• Mount the required disc (slicing, shredding or
other – options.
- Turn the dics clockwise to insert the bayonet and
keep on turning closwise until it reaches the pin.
6
button to automatically hook the discs in the cor-
rect position.
BE CAREFULL WITH THE DISC BLADES!
PICTURE
- To remove the disc, turn it in the opposite direction
and lift it using the finger holes at the edges of
the disc.
- Close and lock the cover.
2) Cutting into chips or cubes (option)
• Mount the ejector.
• Mount the chips/dice disc in the housing and
check for correct fixing (the assembly area must
be clean). The upper edge of the chips/dice disc
must be placed slightly below the top of the body
of the device.
• Then mount the slicing disc of the same size as
the chips/dice disc and close the cover.
Disc position (figure no. 2)
PART NO.
280300
280416
280317
280102
280126
SIZE
3mm
5mm
7mm
2mm (3 blades)
4mm (2 blades)