Warranty And Liability - SATA air star C Mode D'emploi

Operating manual SATA air star C
EN
1.4. Accessories, spare and wear parts
Always only use original SATA accessories, spare parts and wear parts.
Accessories not supplied by SATA have not been tested and approved.
SATA assumes no liability for damage caused by the use of non-approved
spare parts, accessories and wear parts.

1.5. Warranty and liability

The SATA General Conditions of Sale and Delivery and further contractual
agreements, if applicable, as well as the valid legislation at the time apply.
SATA is not liable in case of
■ When the operating instructions are disregarded.
■ When the product is used in other than the intended ways of usage.
■ When untrained staff is employed.
■ Breathing air supply not in accordance with DIN EN 12021.
■ When no personal protection equipment is worn.
■ Non-use of original accessory, replacement and wear-and-tear parts
■ Not adhering to the specifications regarding quality of air supplied to the
breathing protection device
■ When the product is manipulated, tampered with or technically modi-
fied.
■ Natural wear and tear
■ In case when the product has been exposed to untypical shockloads
and impacts during usage.
■ Assembly and disassembly
1.6. Applicable directives, regulations and standards
REGULATION (EU) 2016/425
Personal Protection Equipment
German Ordinance on the Use of Personal Protective Equipment(P-
SA-BV)
Regulation covering safety and health protection while using
personal protection gear during work
Directive 2014/34/EU
Devices and protection systems for intended use in explosion hazard
areas (ATEX).
DIN EN 14594 class 3A
Breathing protection devices – Compressed air tube devices with continu-
ous air volume flow.
102