SATA air star C Mode D'emploi page 108

Operating manual SATA air star C
EN
Note!
To clean the breathing air of oil vapours, the activated carbon filter SATA
filter 464 (# 92247) must be interconnected. The activated carbon filter
must be checked for functionality and maintained on a regular basis. To
avoid a saturation of the activated carbon cartridge, it must be replaced
after 3 months.
The time indicator is included in the scope of supply of every filter and
replacement cartridge!
Note!
To use the half mask, only use an approved compressed air supply tube
(max. 10 m) with quick-action safety couplings (# 49080).
8.2. Assemble the half mask
Note!
When assembling the half mask, do not press against the thin braces in
the exhaling part.
■ Position the head straps and the lower straps.
■ Fit the mask cap in the nose section of the mask body.
■ Firmly press the mask cap onto the exhalation valve area until it
completely locks into place. Head bands and lower bands may not be
pushed aside during this.
■ Check easy movement of the head straps and lower straps.
8.3. Clean the half mask
Note!
Before using for the first time, the half mask must be cleaned thoroughly
with the provided cleansing wipes.
■ Thoroughly clean the body of the mask [11-4] and rubber seal [11-1]
with the enclosed cleaning cloths.
108